Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Phaser 850 error code 13,004.43

Xerox /Tektronix Phaser error

Phaser 850 error code 13,004.43

by  Phased  Posted    (Edited  )
13,000 errors are Printhead thermal control fault codes.

13,004.43 Indicates the left side heater is not heating at all, or is heating too slowly.

Make sure the printer is not located near direct air conditioning outlets.

Turn the printer off. Wait until there are no more noises coming from the printer; in some cases this may take several minutes. Remove the power cord for at least 30 seconds.

Plug the power cord back in and then turn the printer on.

If you have tried all the listed solutions for this problem and the problem persists, then service is required.

Find a local service provider here:
http://www.office.xerox.com/cgi-bin/resloc.pl?what=Service
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top