Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Programming Public Network DN Lengths
Basic Norstar Programming
On MICS 6.1 you need to go into System programming, Dialing plan, Public network, Pub DN lengths and set the DN length for each dialing prefix. There is an entry to set the default DN length (Prfx
eflt...). Also you can set the DN length for calls based on what prefix is dialed.
The international dialing and special service prefixes also need to be added.
The other prefixes programmed in my system are:
Default - DN Length 7
0 - DN Length 11
00 - DN Length 12
01 - DN Length 17
011 - DN Length 18
1 - DN Length 11
411 - DN Length 3
711 - DN Length 3
911 - DN Length 3
If local calls are dialed as 7-digit numbers, set the Default DN Length to 7 digits. If local calls require that you also dial an area code, set the Default DN Length to 10 digits.
The area codes for local calls that are dialed as 10-digit numbers should be entered as prefixes with a DN Length of 10 digits.
eflt...). Also you can set the DN length for calls based on what prefix is dialed.The international dialing and special service prefixes also need to be added.
The other prefixes programmed in my system are:
Default - DN Length 7
0 - DN Length 11
00 - DN Length 12
01 - DN Length 17
011 - DN Length 18
1 - DN Length 11
411 - DN Length 3
711 - DN Length 3
911 - DN Length 3
If local calls are dialed as 7-digit numbers, set the Default DN Length to 7 digits. If local calls require that you also dial an area code, set the Default DN Length to 10 digits.
The area codes for local calls that are dialed as 10-digit numbers should be entered as prefixes with a DN Length of 10 digits.