Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

To make PRI /T-1 lines overflow if busy to local LS/DS lines

Basic Norstar Programming

To make PRI /T-1 lines overflow if busy to local LS/DS lines

by  mroberts  Posted    (Edited  )
Build route 001 to use Pool A which has the PRI/ T-1 channels in it. Then set up Route 002 to use Pool B which has your local LS/DS lines in it.

Go under Services to SCHED: NIGHT, press Show, set service to manual. Press Next and set OVERFLOW to Y.

Under DEST CODE 9 set NORMAL: 002, press Next and set NIGHT: 001.

Then whoever is the control set will press Feature 873, Password is 266344. The screen will show SERVICES ON. This will stay on the phone at all times. If it doesnÆt then your overflow is no longer working and all calls are going out over the local lines.
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top