Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

WHAT IS THE WIRING & PROGRAMMING PROCEDURES FOR A CAP MODULE

Norstar Wiring

WHAT IS THE WIRING & PROGRAMMING PROCEDURES FOR A CAP MODULE

by  hawkflorida  Posted    (Edited  )
[color red]WIRING:[/color]

The Norstar KLM needs an external power source. A way of providing this source is by wiring in the VP324 24-volt DC power supply. In this example a 6 conductor modular jack is being used. The power supply can power 2 KLMs. To connect second KLM you will add another power pair to the 3rd pair on the 6 conductor modular jack. You can have a maximum of 5 CAPs(10 KLMs) ôcentral answering positionsö per system. The CAP can only be a 7324 and you can attach 2 KLMs to the 7324.

1st KLM Power Pair
pin 5 Yellow -24 V
pin 2 Black Gnd

2nd KLM Power Pair
Pin 6 Blue -24 V
Pin 1 White Gnd



[color red]PROGRAMMING:[/color]

1. Have the CAP modules attached to the telephone with power supplied.
2. Enter SYSTEM PROGRAMMING
3. Select SHOW and then select NEXT to CAP ASSIGNMENT
4. Select SHOW
5. Cap1:none is displayed, select CHANGE
6. Cap1: xxx, enter the extension number of the CAP with one or two KLMs attached.
7. Exit programming
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top