Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Use the Report task to run TEST and STATUS commands

Avaya tips and tricks

Use the Report task to run TEST and STATUS commands

by  MadAccess  Posted    (Edited  )
Instead of running TEST and STATUS commands from GEDI or Emulation, run these using the Report task under the Advanced tab. It will save you from pressing Next over and over and puts the output into a file you can easily refer back to.
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top