Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Wiring a polycom video conf unit to a G3 or S8XX0

Miscellaeneous

Wiring a polycom video conf unit to a G3 or S8XX0

by  phoneguy55  Posted    (Edited  )
If you need to connect your polycom to your definity so that you can make and recieve video calls via your PRI, then this document should help.

http://img143.imageshack.us/my.php?image=wiringpolycomtog3ors8xx09yl.jpg

Set the polycom to AT&T multipoint.
----------------------------------------------------------

Data Module setup. Create 4 of these in order. ie 5001, 5002, 5003, 5004.

Data Extension: 5001 Name: Video Conf 1
Type: wcbri COS: 1
Port: 01B0201 COR: 8 Multimedia? n
TN: 1


ABBREVIATED DIALING
List1:

SPECIAL DIALING OPTION:



CIRCUIT SWITCHED DATA ATTRIBUTES
Default Duplex: full Default Mode: async Default Speed: 1200

DATA MODULE CAPABILITIES
Default ITC: restricted Default Data Application: M2_A


BRI LINK/MAINTENANCE PARAMETERS

XID? n Fixed TEI? n
Country Protocol: 1 Endpt Init? n
-----------------------------------------------------------

Then change the router pattern.

Change your route patten.

TSC = y

CA-TSC Request = as-needed

ITC = both

BCIE = ept
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top