Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

How do I setup the Alerter to use SMTP Authentication?

ArcServe Alerter

How do I setup the Alerter to use SMTP Authentication?

by  SKody  Posted    (Edited  )
1. Install SMTP from IIS.
2. Run IIS Admin.
3. Configure the Virtual SMTP to only allow relaying from the IP Addresses that need to send from this server.
4. Configure a "Smart Host" to use the SMTP server that requires authentication.
5. Configure the username and password that is required for the "Smart Host"
6. You can test the new SMTP settings by using BLAT.
7. Configure the Alerter SMTP settings to use the local SMTP server.
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top