Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Programming DISA

Dialling into a BCM

Programming DISA

by  curlycord  Posted    (Edited  )
In this senario:
Used to dial in remotely to page sets
BCM using spare ATA then back into spare trunk port
AA is answering the trunk port on 0 rings

Example is ATA DN 251 and Trunk port 062 with restriction filter 5 and COS 00

Lines/Active/062/Properties/
-Trunk Mode = Supervised

Lines/Active/062/Preferences/
- Auto Answer, DISA =Yes

Filter #5
-Restrict any digits required such as 0 for overseas if you allow Pool or BlocX access

CallSecurity/Remote Packages
Package 01, Remote Page = Yes, and add Pool and/or BlocX if need

CallSecurity/ClassOfService/00 Enter 6 digit password, restriction filter 5, remote package 1

Sets/251/Capabilities/Recieve Short Tones = Yes , this will allow dialtone to be broken when DISA answers.

Sets/251/Capabilities/ATA Settings/ Disconnect Supervision = Yes


Speed Dial dialing string for remote user:
XXX-XXX-XXXXP251PPXXXXXXP*6XX

Explaination of string in order of appearance:
First set of X's = phone number
P is one pause (or one comma on on moble phones)
251 = DN of ATA
PP = two pause's (or two commas)
Second set of X's = COS password
P is one pause (or one comma)
6 = Page code
X = Sets or Speakers or Both ( 1 for Sets, 2 for Speakers or 3 for Both)
X = Zone # (1 for Zone 1, 2 for Zone 2 etc etc)
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top