Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Receive Connectors

Configuration

Receive Connectors

by  Zelandakh  Posted    (Edited  )
By default, when you set up new connectors to interoperate with your Exchange 2003 servers, you will find that the connectors are set with 10MB limits. With any encapsulating overhead this means less than 10MB.

Drop to a Powershell command prompt and type:
Get-Receiveconnector | Select identity,MaxMessageSize

This will list the 10MB limits of both your client connector and default connector (if you have followed standard practice). Now increase it. Since this is for internal traffic, make it large.

Set-Receiveconnector -identity "server\site" -MaxMessageSize: 300MB

Substitute server\site for the exact output in the get- results. Then repeat the get- command to ensure that the new limits are in place.
Register to add this FAQ to your archive
Register to rate this FAQ  : BAD 1 2 3 4 5 6 7 8 9 10 GOOD
Please Note: 1 is Bad, 10 is Good :-)

Part and Inventory Search

Back
Top