How To Install DIDs on a 8X24

Installing the cards

Power down just the trunk module, put your cards in and power it back up.

A. Configuration û Next until you see
D. Maintenance û Show
1. System version û Next to
3. Module status û Show
Show module û Show
XX sets on KSU û Next
XX Lines on KSU û Next
Module 3 empty -
Programming the Target Lines

A. Configuration û Show
1. Trk/ Line Data û Show
Show line: Dial in 081 (this is your first target line) Target lines number 081-184
RecÆd #: None û Press Change
RecÆd #: dial in the digits being sent by telco. Then press Next
Line Data û Show
Line Type: Public û Press Change
Private To: dial the ext # you want to have the target line show up on.
Press Next
PrimeSet: 221 (operator) û Next
Aux: Ringer: Y û Next
Auto Privacy: Y û Next

Show line: dial the next target line number 082
Program one target line for each DID. Then assign the target line to the phone (see below):

Assigning the Line:

Press your Header button until you see:
A.Configuration
1. Trk/ Line data û Next
2. Line Access û Show
Show set: dial the ext. number
Line assignment û Show
No lines assigned (make sure only the lines you want to appear on the phn are assigned, otherwise remove them)
Press Add
Add Line: dial in target line number (ie., 081)
Line081 assigned û Next
Answer DNS û Next
Ringing û Show
Line 081 û Ringàà

Press Header button twice and youÆll be back to
Show set - enter in the next extension number and continue assigning all your target lines to the appropriate extensions.