Have a customer that has IP-KCCIS between 2 locations that has been working with no issues for years. They recently installed Velo Edge 620 equipment and ever since then they have 1 way audio between sites. They say no IP Address's changed. I informed them to make sure ports 10020-10531 are open and not being blocked as well with SIP ALG disabled. I have a scheduled conference call with them. Is there anything else I should ask the IT company. We have no access to remote programming and they do not want us onsite. Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
SV9100 CCIS Issues
- Thread starter erniejoey
- Start date
Ok, so they changed something now it doesn't work. Logic dictates it's an issue with their network. They should be using wireshark and go over all their routing. There is no way they can point to the phone system and you should be billing hourly for this. I would bet this is something silly easy in their equipment. I know is some equipment the GUI will should something different than when you get into a terminal with Putty (I am looking at you SonicWall) 
. The only way it COULD be a pbx issue is if they are resetting the phones system (a lot) and have corrupted the database. I have actually seen an IT company do this like 50 times at one site.
. The only way it COULD be a pbx issue is if they are resetting the phones system (a lot) and have corrupted the database. I have actually seen an IT company do this like 50 times at one site.- Thread starter
- #3
I totally agree and on our previous conference call I told them NOTHING in the phone system has changed and it broke AFTER they made changes. Check routing, ports, SIP ALG, etc. One site is all Digital & Analog phones and the other site is all VOIP phones. Both locations have their own SIP trunks which are fine. It's funny, they want call examples to trace on Wireshark but the customer does not want us onsite, SMH...
- Thread starter
- #5
FYI...The network engineers ran Wireshark with call examples. The network engineers had me reboot both SV9100's and after that it works fine now. The network engineers said that when they installed their new equipment sometimes the MAC Address's do not release from the NEC equipment. Never seen that before. Thanks again CoralTech...
- Status
