DigitalPhreak
IS-IT--Management
I have 3 locations. Between location A and B I have a dedicated T1 that uses vanguard routers. Between location A and C I have a vpn using pix 506e's. At the main location (A) I have to use the vanguard router that leads to location B as location A's default gateway because for some reason the static route that I have configured on the pix at the main location (A) does not successfully tell devices at the main location (A) where location (B) is. The routes on the vanguard at location A that I have do however work. It may be that Im just dont know what Im doing but it seems to me that everything is right.
Here is the route excerpt from the config:
access-group outside_in in interface outside
access-group inside_access_in in interface inside
route outside 0.0.0.0 0.0.0.0 x.x.x.x 1
route inside 10.2.0.0 255.255.0.0 10.1.0.1 1
This is the configuration on both the pix at my main location and the location that is connected over the vpn. I still however cannot reach the 10.2.0.0 network when I use the pix's as my default gateway in either location. This leads me to assume the routes arent working. Correct? How to fix?
Here is the route excerpt from the config:
access-group outside_in in interface outside
access-group inside_access_in in interface inside
route outside 0.0.0.0 0.0.0.0 x.x.x.x 1
route inside 10.2.0.0 255.255.0.0 10.1.0.1 1
This is the configuration on both the pix at my main location and the location that is connected over the vpn. I still however cannot reach the 10.2.0.0 network when I use the pix's as my default gateway in either location. This leads me to assume the routes arent working. Correct? How to fix?