Solaris EMC San problem

[dandan123]

I'm a newbie with SANs so bear with me.

I have a 2 Solaris 8 Boxs which are attached to our EMC SAN. These boxes will form a cluster eventually so they are both configured to see the same LUNS on the SAN. The should see 3 LUNS.

Each box has two single port emulex LP9002 HBAs and there are two ports on the SAN (SPA and SPB I think) so each LUN has 4 paths to it.

On one Solaris Box everthing is fine on the other box I'm not seeing 2 LUNS, where do I start ? I've checked lpfc.conf, sd.conf and they seem ok (compared to the other box). I think I may have messed up my path_to_inst file, how can I regenerate this file ?

Thanks.

DD

 

[Novelli]

Hi,

do a "touch reconfigure"
and then a boot -r

Be sure, that you registered the WWN´s of the HBA on the clariion and that your zonening in the switch is correct before !



Cheers Novelli
Novell Master CNE + CDE
EMC Networker LCNS

http://www.eckertweb.de