SIP Line, maximum?

[cruzades]

Hi,

Given:
IPo 500 7.0(12)
Sip Trunk Channel License: 20


I would like to ask if there is a maximum number of entries for the SIP Line? I know the fact that each SIP Line can handle 30 SIP URI, and all the DID will share with the 20 channel license.

 

[IPOfficeIreland]

why would you want to create that many sip uri? You can use wildcard * to accept any number from the itsp and then just use ICR to route the call.

 

[hairlessupportmonkey]

I still add all the numbers into the URI - makes life easy tracking them for future reference. sadistic I know.

ACSS - SME
General Geek

 

[cruzades]

@IPOfficeIrelan

Authentication Method: IP

I have 44 SIP credentials.
I created Trunk#1 for the first 30 SIP credentials (that's the maximum per SIP line).
I created 30 SIP URI statically.
Group# (In/Out) = 30
ITSP = 12.12.12.12

With the remaining 14 SIP cred
I created Trunk#2 for the remaining 14 SIP credentials
I created 14 SIP URI statically.
Group# (In/Out) = 31
ITSP = same as the Trunk#1

--------------
Problem
1. If I'm going to call out using Trunk#2, works fine, but inbound to Trunk#2 gives out 404 Error.
2. If I'm going to remove 1 cred from Trunk#1 and add 1 SIP cred from Trunk#2 to Trunk#1, inbound for that SIP cred (DID) works fine.
---------------

Having what have you said:

In Trunk#1, I may opt to use * in URI table (Local URI, Contact, Display) instead of adding all the credentials statically to URI?
As long as the Trunk#2 (have same Group# as Trunk#1) is on "Idle" mode, will now be able to accept inbound call, since we use wildcard?

Please advise.

TIA.

 

[cruzades]

BTW, here is the screenie of my SIP URI's

 

[tlpeter]

Get a proper SIP provider which delivers one credential for all DID's
You should not need a login credential for each DID which give these problems.


BAZINGA!

I'm not insane, my mother had me tested!