SAT lockout

[telcoguy]

Anyone know the solution to this one:?
I lost all access to the console via IP SAT,INADS, or datamodule access on a definity 9.5x
For some reason the SAT process locked up, it seams.
I get the message < Resources not available > and then it will disconnect on me..
The locally attached serial console is the only means of access that still works.
I tried resetting the c-lan, busy-ing out the Ethernet DAT,sofar, all without any results...

 

[nohuhu]

telcoguy,

use 'status login' command to see who's logged in now and then 'reset login x' to remove locked logins.

 

[charmstrong]

Try statusing the link associated with the data module associated with the c-lan.

Make sure the c-lan is connected and can talk to the network.

That deal with the ip side, am a bit confused about what you are saying in terms of inads - your trying to dial in via the inads port and that says resource unavailable aswell?

 

[telcoguy]

Charmstrong,
when I dialed in through the INADS port, I just got a dead screen.
The C-lan could be pinged, and actually the message I got came from the system, so i'm able to reach it, it just won't give me a terminal session.

Dwalin,
That might work I'll keep this one in mind for next time.
We ended up rebooting the system last night.
Odd enough even after the reboot the issue was still there
but once it had done all it's checks it cleared the issue, after it was back up for about 10 mins.

 

[phoneguy55]

I had an issue simmilar to this. Everything was locked including the terminal. A reboot solved my problem as well.

http://www.tek-tips.com/viewthread.cfm?qid=1229403&page=2