Ringing Services

[srachmaninoff]

I have a MICS 6.1 that I am trying to program for night ringing. I have programmed extension 300 as the control set and I have Night ringing set to manual When I use feature 871 to turn on the services, the system waits about 3 seconds and says "Access Denied." Can someone tell me why ext 300 cannot turn on this "Night Ringing" service?

 

[fireeater]

did you setup the control set for lines or sets

if set for lines and the line is not active ,will not work

HALLOWED ARE THE ORI

mike

http://www.ics-on.ca

 

[RikRodgers]

You may need to power cycle the system.

 

[whender]

It is possible that the set you are entering F981 on is not the control set for the line for night service. This is most probable cause. Must activate night service from set controlling line.

 

[safeharbor]

Also, make sure that you make your Control Set change from the actual default Control Set! (Normally 221) I have had this problem in the past...