Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Resiliency on Mitel 3300
- Thread starter WJ2600
- Start date
danramirez
Programmer
have a look at resiliency guidelines on mol
Supernova99
Technical User
how can we help?
Share what you know - Learn what you don't
Share what you know - Learn what you don't
- Thread starter
- #6
Supernova99,
i have 2 elements (3300)in a cluster, 2 ip phones are programmed in each system, i'd like to make these devices resilient, i made the sync between the two elements, it went smoothly,
when programing the devices in the RDN, should i include the local & the remote extension in this form or only the local/remote one?
i have 2 elements (3300)in a cluster, 2 ip phones are programmed in each system, i'd like to make these devices resilient, i made the sync between the two elements, it went smoothly,
when programing the devices in the RDN, should i include the local & the remote extension in this form or only the local/remote one?
Supernova99
Technical User
I will need to know the software level as there has been a lot of changes in recent versions
Share what you know - Learn what you don't
Share what you know - Learn what you don't
In MCD 5 you can't access the RDN form to alter it so I am assuming your software level is below that. The RDN form shows the extensions contained on other cluster elements. In order for resiliency you need your 3300's clustered. Past that we would need to know what software load you are at.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
- Thread starter
- #10
If you have Migrated the DB to SDS mode then you no longer have access to the Remote Directory Form.
If you've properly Clustered your system, you designate the Secondary system for the user via the User and Config form and the system takes care of the rest.
You must reset the phone after you make it resilient for it to get the secondary programming.
**********************************************
What's most important is that you realise ... There is no spoon.
If you've properly Clustered your system, you designate the Secondary system for the user via the User and Config form and the system takes care of the rest.
You must reset the phone after you make it resilient for it to get the secondary programming.
**********************************************
What's most important is that you realise ... There is no spoon.
- Status
