Replace M7310 with T7406 1

[jdlrez]

I would like to take out one of the M7310 sets at one of my locations and replace it with a cordless T7406.

Is this basically hot swappable, or is there any sort of programming that needs to be done to the PBX?

I am not concerned with programming specific buttons on the T7406, as all it needs to do is make and receive calls.

Can I just swap the cord and go?

Thanks in advance.

 

[jerryreeve]

just plug in the station that is the 7310 to the base station port 1 and go.

unless you are running out of ports you might want to consider keeping the 7310 in place and set the 7406 up to answer dn from the 7310. best of both worlds then.

----------------------------
Hill?? What hill??
I didn't see any $%@#(*$ Hill!!
----------------------------
JerryReeve
Communication Systems Int'l
com-sys.com

 

[jdlrez]

Thank you, that sounds good.

 

[YnotPhone]

This PDF might help in button programming - Page 37.

http://pdf.textfiles.com/manuals/TELECOM-F-R/Nortel T 7406 Cordless Telephone Installation Guide.pdf

Ensure that Auto Set Relocate is turned off, that is if you want the set to keep the same extension number.