Does anyone know of any issues with Rel 9.1 and the IPBS2 DECT antennas? We are unable to get them to sync with the system on the new 9.1. I tried 9.1.3, 9.1.4, 9.1.5. The antennas show connected in the antenna gui but in status the master status is n/a and the PBX status is n/a. We have installed a bunch of these in the past with minimal problems but this bunch really seems to have an issue?? I have been on the line with both our vendors we use and they say the config should be working??
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Release 9.1
- Thread starter Trems
- Start date
intrigrant
Systems Engineer
I have had no problems with DECT R4 on any 9.1 version, make sure the units have the firmware loaded as supplied in the ADMIN software suite.
We have a mix of provisioned and not provisioned installs, the only issue we have is that missed calles are preceeded with a + which should not be there.
We have a mix of provisioned and not provisioned installs, the only issue we have is that missed calles are preceeded with a + which should not be there.
- Thread starter
- #3
Thanks, I was able to connect...the issue I found was if you look into the DECTR4 folder in release 9.1.5 vs 9.1.4 the handset bin files seem to be reversed...The 7.2.22 antenna works with 4.3.3 handset software not the 4.3.2 software that is in the 9.1.5 DECTR4 folder..Once we put the latest handset SW (which was in the 9.1.4 release) with the latest antenna SW (in the 9.1.5 rel)they came up!
- Status