I posted this question in the CR - Gen Forum, but the response time over there is a little bit slower than here. May be somebody can answer this here a tad faster.
There was an item in the FAQ that is similar, but I got lost reading it.
I'm kinda new with Crystal Report, so forgive me if my question might sound stupid.
I just created a Crystal report which I will run on my VB application. As I was designing the report, I realized that I can only reference an existing table in my database. I would want this report to use a recordset that I will create in my VB application. Is there anyway I can pass this recordset to the report file during run-time.
Any help will be greatly appreciated.
There was an item in the FAQ that is similar, but I got lost reading it.
I'm kinda new with Crystal Report, so forgive me if my question might sound stupid.
I just created a Crystal report which I will run on my VB application. As I was designing the report, I realized that I can only reference an existing table in my database. I would want this report to use a recordset that I will create in my VB application. Is there anyway I can pass this recordset to the report file during run-time.
Any help will be greatly appreciated.