PRI Target line call forward

[ljclives]

I have a target line DID I need to call forward to another external number. How do I do that? I have tried to forward the ATA2 it is assigned to unsuccessfully

 

[silver987]

Assign the line to a phone and forward the phone.

Wayne T

 

[curlycord]

You can assign the Target line to a spare set or even reception if room then do a "Line Redirect"


________________________________________
We take the time to try to answer your questions for free, please return the favor and take the time to answer back and include any resolution you found elsewhere, thanks.

=----(((((((((()----=

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[silver987]

I don't think you can redirect the line because it is incoming only. Am I wrong?

Wayne T

 

[curlycord]

All lines (Loop or Target) can be redirected.

Also if they have a RAD on site you can use the set simulator to do it as well.


________________________________________
We take the time to try to answer your questions for free, please return the favor and take the time to answer back and include any resolution you found elsewhere, thanks.

=----(((((((((()----=

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[ljclives]

It was not working when I did it from even a digital phone it was because Telco did not have a feature activated on the PRI. Hey while I have you. The phones that are installed in this building are running thru a fiber connection and an MCK 6000 Gateway. I had a call this morning that when some dialed '9' for a trunk they got 'expensive route' on their display but were still able to make the call. Any thoughts?

 

[curlycord]

Start a new thread please.....easier to track.


________________________________________
We take the time to try to answer your questions for free, please return the favor and take the time to answer back and include any resolution you found elsewhere, thanks.

=----(((((((((()----=

http://www.curlycord.com

Toronto Canada

http://www.telcopc.ca

 

[ljclives]

Got it covered. I started a new thread 'Expensive Route message' I looked at some other threads with that did not help or I missed something