Power fail 1

[ccarmock]

On BCM 50 with in-built analogue trunks is there any power-fail transfer provision on the RJ21 connector?

I am about to replace a CICS with a BCM 50 Release 5 and ideally would like to enable powerfail working if it exists.

Under BCM Release 5 I see there is an alarm code for powerfail transfer.

On a seperate note - System Update 002 to BCM rel 5 at last fixes the spurious router not present alarms.

 

[snowman50]

power fail is located on pair 5 for line 061
This is the analogue extn port 233(default)

when power is off dial tone from line 061 is directed to this port