Need to test E1

[Avaya Naresh]

Hi,

we have 10 E1's in our system, we want to test One E1.
Please help, we need to outgoing a call with particular E1.

 

[bignose21]

just build another route data block that matches config for current one (IDC etc.) that all the PRI's are in. Move the channels of the PRI you want to test to the new route. Enter an ARRN in LD 90 for your test number with an RLI to send the call to your new route.

As you matched the config on the RDB any inbound calls that might arrive on the PRI would work as usual.

 

[Avaya Naresh]

we are looking for outgoing call , we have taken dch traces while making outgoing call and we are getting below mentioned traces.
Please help to understand where is the issue.

DCH 38 UIPE_OMSG CC_SETUP_REQ REF 0000004F CH 38 30 TOD 12:38:09 CK 7FC8D800
PROGRESS: ORIGINATING END IS NOT ISDN
CALLING #:22002767 NUM PLAN: E164 TON: NATL
CALLED #:97257088 NUM PLAN: E164 TON: UNKNOWN

DCH 38 UIPE_IMSG CC_PROCEED_IND REF 0000004F CH 38 30 TOD 12:38:09 CK 7FC8D976

DCH 38 UIPE_IMSG CC_DISC_IND REF 0000004F CH 38 30 TOD 12:38:09 CK 7FC8D99C
CAUSE: #1 - UNASSIGNED NUMBER

DCH 38 UIPE_OMSG CC_RELEASE_REQ REF 0000004F CH 38 30 TOD 12:38:09 CK 7FC8D99C

DCH 38 UIPE_IMSG CC_RELEASE_CONF REF 0000004F CH 38 30 TOD 12:38:09 CK 7FC8DA60

 

[bignose21]

You are sending a call to 97257088 call TYPE unknown and the far end is telling you it is an unassigned number. If the number is valid the far end does not have the routing in place to send the call. Or is it just invalid number can you call it from mobile etching.

 

[Avaya Naresh]

given number is valid and i was also trying the same with my number but getting the same error

 

[bignose21]

What is it going to pstn or another pabx

 

[bhassell2000]

Do you need to be passing the 9?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell