Hello. We have a MCD 4.2 at one of our sites. There is a single PRI servicing two separate tenants. Our objective is to bill back each tenant based on their LD usage. We have Prairie Fyre and accounting codes but we require a simpler way to separate the billing between entities. We would like to route all LD calls for one tenant over our IP/XNET trunks and out another PRI entirely. It seems Class of Restriction would do this..how would I setup the COR to ensure that the long distance calls go out another PRI and retain calling party number while at the same time sending all local calls out the local PRI trunks? thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Westi on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mitel Class of Restriction_Outbound LD Dialing_Tenant Site
- Thread starter acskmk
- Start date
You create a route list. Route 1 is local route 2 is IP. You then use COR to prevent whatever extensions for accessing route 1. They will then use route 2.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
I'd tell you a UDP joke but I'm afraid you won't get it. TCP jokes are the best because you always get them.
- Thread starter
- #3
Thank you. Will I need to modify the ARS Leading digits for 9 to perform a check on COR Groups? We also have 3 IP/XNET trunk routes. How do I define which one it uses they are designated 11, 12 and 13. Once I have worked out the COR I then assign the COR # in station attributes for each Dn correct?
- Status
