Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

MICS in maintenance 2

Status
Not open for further replies.
jonsjacks

jonsjacks

Vendor
Jun 18, 2008
91
0
6
CA
HELP! Just connected a MICS. It took quite a while to boot up. When it did, sets say "in maintenance". I can't do any thing. How do I get it out of mtnce??

Jon
 
Sort by date Sort by votes
did you do a **startup command when 1st powered up?
 
Upvote 0 Downvote
Never got the chance. Once it stopped flashing, no time/date just mtnce.


Jon
 
Upvote 0 Downvote
Sounds like it had an expansion in it, and it was removed. Either put an expansion card back in, or short out the capacitor, or connect a phone to each port one at a time until you find the alarm set, that will give you the option to perform a cold start.
 
Upvote 0 Downvote
Thank's guys changed software & startup...

Jon
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Don W
  • Locked
  • Question
Mics software upgrade tools
Replies
9
Views
102
curlycord
curlycord
N
  • Question
Need support on dial 9 Nortel MICS PRI When dial 9 display states Invalid number. Incoming DIDS work fine. Been working for years. Provider 1
Replies
6
Views
491
Nortel dino
N
jsaad
  • Locked
  • Question
MICS GATC going dead 4
2
Replies
24
Views
207
curlycord
curlycord
Michael OConnor
  • Locked
  • Question
Norstar MICS Extension Call Forward External 4
Replies
12
Views
144
ttEstiNg2023
ttEstiNg2023
RedMaligator
  • Locked
  • Question
Nortel MICS connected to Call Pilot
Replies
10
Views
129
curlycord
curlycord

Part and Inventory Search

Sponsor

Back
Top