How 2 block incoming calls

[Zu56]

Hi all,
A user asked me if I could block two specific numbers (one of them international) from being able to reach her DID. I've never done this before but remember reading something on this forum. I tried to search for it but no luck. Can someone help me with this, please?
Definity G3si ver. 12
Thank you

 

[DAVIDPAYNE]

Depends on how much effort you want to put in.
You could intercept here DID and use a vector to check the ANI and reject the call based on the number in a list.
You could also use EC500, setup a dummy station that has no rights to dial anything and assign the 2 numbers you want to block as the off pbx station number for that dummy extension. I am sure they are some other ways as well.

 

[DAVIDPAYNE]

Also look at this.

http://www.tek-tips.com/viewthread.cfm?qid=1541516

 

[Zu56]

Thank you. I do not want to put too much effort in this. I checked the thread you posted and also thread referred to in that thread. A VDN method looks appealing. I just don't know how to tell vector to check for ANI. Would you happen to have an example of such vector?
Thank you

 

[98Converter]

02 goto step 09 if ani = 603xxxxxxx
03 goto step 09 if ani = 585xxxxxxx
04 route-to number 2345 with cov y if unconditionally
09 disconnect after announcement none
10 stop

Thanks,
98C

We are what we repeatedly do. Excellence, then, is not an act but a habit. ARISTOTLE 384-322 B.C.

 

[DAVIDPAYNE]

goto step xx if ani = xxxxxxxxxx

 

[Zu56]

Thank you. Will try.

 

[Zu56]

Ooops. Just found out that ANI/II digit routing is not enable in my system. I guess I'm out of luck here....