Has anyone ever setup an EMMC to run through SES instead of creating a direct SIP trunk on the CM? We upgraded from CM4 to 5.1.2 in order to get the coresident SES on an S8300D and found out that if you are going to use SES coresident you can only have one SIP trunk on the CM and that trunk has to point to SES, thus killing our pre-existing EMMC trunk. Does anyone have instructions for setting up the EMMC to run through SES?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations SkipVought on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
EMMC with SES
- Thread starter ncc63725
- Start date
- Thread starter
- #2
FYI we were able to do this by changing network nodes for emmc in CM to point to the IP of the SES and then within SES creating an adjunct pointing to the IP of the emmc. Took some playing around with it but in the end it works great in case anyone is interested.
- Status
Similar threads
- Locked
- Question