E&M Tie between IPO 8.0 & Mitel SX200D

[dialtonetek]

Hello everyone,

Working on an IPO and a Mitel in the same telephone room.
I have them connected via a T1 set as E&M Tie lines.
IPO to Mitel worked as soon as I connected them. The trouble I'm having is getting the Mitel to communicate with the IPO.
I have the channels set as incoming group 3, recieve digits at 3,
Mitel is sending 3, incoming call route is set to Any voice, line group 3, incoming number of 222(test phone in phone room), destination of 222. Another setup for 110(front desk)
IPO channel timers are at default
Mitel is a SX200D 1003 software, timers are set as
Guard timer is 600ms
debounce timer is 100ms
Outpulse delay timer is 800ms
Interdigit time is 800ms
Wait for delay timer is 5000ms
I believe it's a timing issue, I get a prealerting and it seems like it times out and goes to 110.

Any thoughts?

 

[mattKnight]

5603759mS T1DSP: PRIU DSP 4: read tone, port 1, channel 5, tone '2'
5603759mS T1Dialler: dialler: 0.5: Receive DTMF 2
5603760mS T1Line: line: 14.5: State= Received RxMessage: ReceivedDigit
5603760mS T1Line: line: 14.5: Routing Digit Received 2
5603960mS T1DSP: PRIU DSP 4: read tone, port 1, channel 5, tone '2'
5603960mS T1Dialler: dialler: 0.5: Receive DTMF 2
5603961mS T1Line: line: 14.5: State= Received RxMessage: ReceivedDigit
5603961mS T1Line: line: 14.5: Routing Digit Received 2
5604144mS T1DSP: PRIU DSP 4: read tone, port 1, channel 5, tone '2'
5604144mS T1Dialler: dialler: 0.5: Receive DTMF 2
5604145mS T1Line: line: 14.5: State= Received RxMessage: ReceivedDigit
5604145mS T1Line: line: 14.5: Routing Digit Received 2
5604146mS T1Line: line: 14.5: State= Received RxMessage: Ringing

Ar last,some DNIS information!!!

However, I suspect that the IPO receives this too late - guessing from the position in the trace.

I think yout yimers need to be tweked still - and TBH I'd reset the timers at the MITEL to what they were and tweak the IP end. However, I don't know enough about wink-start (not used in Europe) to be much more help.

Any US guys able to help more?

Take Care

Matt
I have always wished that my computer would be as easy to use as my telephone.
My wish has come true. I no longer know how to use my telephone.

 

[dialtonetek]

Matt,
Thanks for all your help!