Duplicate Subnet Number error after 3.7 upgrade

[lewmar]

Hi,
I had rls 3.6 BCM1000 and my LAN2 was 192.168.0.190. After upgrade to 3.7 LAN2 IP was defaulted to 10.10.11.1. Now if I try to change it back to 192.168.0.190 I get "Duplicate Subnet Number" error. I understand that upgrade has populated LAN2 address somewhere, and I have to delete it from there but I can't find that place. I went trough almost all options and features which have any IP associated with them with no luck.
Any hint appreciated.

Lewmar

 

[senk1s]

Did the IP of LAN1 also get defaulted?

 

[lewmar]

Yes, LAN1 was a public IP before upgrade and it was a publiched one in thet BCM. It got defaulted to 10.10.10.1, but it had no problem changing it back.

 

[MagnaRGP]

Seen this happen before on a 400 upgrading to 3.7 from 3.5. Got the dreaded BFT issue occuring during the upgrade and corrupted some of the registry. All I could do was back up the Telephony and Voice APPS and reimage the unit on a new HD to 3.7, reinstall all keycodes and then restore the backup.

Couldn't figure any other solution in a timely manner.

Good Luck though.

 

[acewarlock]

Go in though the Serial port and use menu item 2 then Q