jacksondorado
IS-IT--Management
I an trying to get my dwl 900AP working. Does anybody know how to get the SNMP to recognize the AP, and connect to the DHCP server/router? I have been using the Linksys WAP 11 utilites.
I am using the dwl 900 to wireless connect to a Dlink wireless router in the same room. I restored the factory defaults on the dwl 900, entered my ESSID, enabled DHCP, left the IP address as the default, primary port set to wireless.
The USB utility recognizes the AP but the SNMP cannot connect to it. The dwl 900 AP is connected to a switch and my laptop is also connected to the switch. And the LAN light is on and the WLAN light blinks faintly and rapidly.
thanks for any ideas. "There's no such thing as 'should have'."
I am using the dwl 900 to wireless connect to a Dlink wireless router in the same room. I restored the factory defaults on the dwl 900, entered my ESSID, enabled DHCP, left the IP address as the default, primary port set to wireless.
The USB utility recognizes the AP but the SNMP cannot connect to it. The dwl 900 AP is connected to a switch and my laptop is also connected to the switch. And the LAN light is on and the WLAN light blinks faintly and rapidly.
thanks for any ideas. "There's no such thing as 'should have'."
