Definity One remote dialin

[Avayatech713]

Trying to remember the setup to dial into a Definity One - TN795 or TN2314 - been a couple of years. I remember it being like the connection setup for getting into a LX1000 remotely??

I established the dialup connection via modem but I don't remember if I setup the IP connection via ASA or browser as I need to setup for port 23 and don't think I can make that setting thru the IE browser - bt I can thru ASA for an IP connection. Have all my logins etc - just need a refresher in the connection and login process.

 

[Avayatech713]

Actually an S8100 not a Def One - as it is the TN2314 w/ R11 SW load - but should be the same remote connection setup steps.

 

[Midstream]

You do the dial up like you stated, then launch your browser, put in the IP of the processor, login there and ASA launches from inside the browser. I think =) !

It's been a while.

 

[Avayatech713]

Thanks Rockspop - don't know that I can "launch" ASA inside a browser. Can setup ASA for IP connection but that fails when I try to connect to the switch's IP address and port 23 config - after I connect via the dial up connection.

 

[Midstream]

Try port 5023.

There's a link "buried" in the browser for doing the system admin via ASA, isn't there?

 

[Avayatech713]

Has to be Port 23 as that is the port setup on their S8100 - TN2314 Processor for IP

 

[Midstream]

Sorry, sounds like you know more than I remember about connecting to this thing. I don't have access to my VPN right now or I'd get a cheat sheet from my network drive.

Have you tried the manual?

http://support.avaya.com/elmodocs2/comm_mgr/r2_0/245801_1_1/233146_3/233146_3.pdf

dial up starts on 149.

 

[Avayatech713]

RP - thanks - The only problem is they only have the New Connection Wizard for WIN 95 & WIN2000 - none for XP and it is a bit different.

I get to login but the docs show I have to login with rasaccess but don't have the default PWD. I have the switch login/PWD but not the Ras....