I have created a custom report that looks good on the screen, but when I try to print I'm only getting a small section of it and it's not filling the page. How can I fix this?
The report was a task sheet with resources.
I obtained it by going to Report -> New Report -> Blank and then filling out the table data as needed.
It looks fine when I create the report. Then when I try to print it looks too big for the page, so I shrink it in page setup and only part of it appears on the page.
How do I fix it? How am I not formatting the report correctly?
The report was a task sheet with resources.
I obtained it by going to Report -> New Report -> Blank and then filling out the table data as needed.
It looks fine when I create the report. Then when I try to print it looks too big for the page, so I shrink it in page setup and only part of it appears on the page.
How do I fix it? How am I not formatting the report correctly?