Card NTAK79BC E1 PRI Release 6

[Elendil326]

Hi

I'm trying to connect Nortel option 11c with card NTAK79BC to Asterix using QSIG, is it possible? I've found that it can support Q.931 by moving the switch1-2 but I'm not pretty short that will make it capable of all QSIG protocol stack.

Thanks for answering.

 

[MossEng]

The NTAK79 PRI Card does not support QSIG, It supports DASS, DPNSS and 'Q931', which is the Nortel Propriety version of Q931, now referred to as MCDN. You need a NTBK50 PRI card with a NTBK51 daughterboard for QSIG, If there are no other PRI cards in system you will also need a Clock Controller daughterboard.

 

[Elendil326]

Thanks a lot for answering MossEng, now I have another question, the Q931 version of Nortel can support communication with Elastix or Asterisk, I have been reading that it doesn't support Euro-ISDN but it could be possible a configuration with another type of ISDN?

 

[Firebird Scrambler]

NTBK50xx supports Euro ISDN 30, QSIG, Q931 etc.

All the best

Firebird Scrambler
Meridian 1 / Succession and BCM / Norstar Programmer in the UK

http://www.linkedin.com/in/davidbromley

If it's working, then leave it alone!.

 

[Elendil326]

Thanks a lot, but right now I can´t just change the card, I need to make the comunication with Asterisk with this card, I'll try with the nest configuration, it seems to work with the NI2 (National ISDN2) but I'm not really sure if the card will support this ISDN.

Bye the way, the card has th eoption to work with DASS/DPNSS1 or Q931, wich one shall I choose when configuring it to work with NI2? The DCH condiguration looks like this.

Nortel DCH configuration
-------------------------------
>ld 22
PT2000

REQ prt
TYPE adan
.
.
.
ADAN DCH 11
CTYP TMDI
CARD 01
PORT 1
DES did
USR PRI
DCHL 1 0
OTBF 32
PARM RS232 DTE
DRAT 64KC
CLOK EXT
IFC APAC
CNTY HKNG
ISDN_MCNT 300
CLID OPT4
PROG NCHG
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID **
RCAP BRI
MBGA NO
OVLR NO
OVLS NO
T310 10
INC_T306 2
OUT_T306 2
T200 3
T203 10
N200 3
N201 260
K 7
.
.
.

Actually I got it from another post where they discovered the communication works just fine when using NI2 beween Nortel and Asterisk. Thanks a lot again.