Can't dial 900 numbers

[OpethBWP]

Hey All..

I am trying to get 3 stations to be able to dial 900's, these are the only 3 that will dial them so I can not comepare to other stations.

Rather then just open all 900's I have them built as SPN's

SPN  19002634000
FLEN 0
RLI  2
SDRR NONE
ITEI NONE

RLI 2

RLI  2
ENTR 0
LTER NO
ROUT 0
TOD  0 ON  1 ON  2 ON  3 ON
     4 ON  5 ON  6 ON  7 ON
VNS  NO
CNV  NO
EXP  NO
FRL  0
DMI  0
FCI  0
FSNI 0
SBOC NRR
IDBB DBA
IOHQ NO
OHQ  NO
CBQ  NO

ENTR 1
LTER NO
ROUT 0
TOD  0 ON  1 ON  2 ON  3 ON
     4 ON  5 ON  6 ON  7 ON
VNS  NO
CNV  NO
EXP  NO
FRL  0
DMI  0
FCI  0
FSNI 0
SBOC NRR
IDBB DBA
IOHQ NO
OHQ  NO
CBQ  NO

ISET 0
NALT 5
MFRL 0
OVLL 0

Example Station

DES  54
TN   021 0 00 01
TYPE 2616
CDEN 8D
CUST 0

AOM  0
FDN  2828
TGAR 11
LDN  NO
NCOS 5

I then checked the NCOS of the stations to that of RLI 2 and made sure it was a higher number.

Yet I am still getting a busy signal. I can't imagine I need to allow anything in the SPN as this was working and from what I can tell no one changed anything..

Any suggestions?

 

[bigindian65]

Don't build it with 1900xxxxxx, just build the spn w/ 900
Reference an RLI that only those 3 can use with a high FRL, match only those 3 sets with a NCOS that meets the FRL of that route.

 

[bigindian65]

build 1900, everything else as above

 

[TAnselm]

RLI 2 specifies FRL of zero....
According to that anyone should be able to use that route.

 

[bigindian65]

That's why I said build a rte/phone with hi frl/ncos

 

[HarrisD1200]

I'm sure you've already checked this, but are you certain that your carrier isn't blocking 900/976, and that's where the busy is coming from?

 

[3tdp33ler]

cls unr ?
tgar 0 ?

 

[DeNDT]

I agree sounds like the carrier - most carriers block 900 numbers - go right on one of the trunks through the maintenance set and try to place the call - if you still get the same responce call your carrier