BCM networked to CS1000

[ccarmock]

I have a test BCM 50 (rel3) with VoIP trunks enabled connected to a CS1000 (5.5 software) using H323.

CDP is being used as a dial plan between the two.

Calls can be made in both directions. The destination system phone displays the number of the calling phone. However the names do not get displayed. Is that supported?

If so could anyone give me some pointers to look at to enable that?

The CS1000 is networked to a number of other CS1000s via the same H323 trunsk andm names do pass between them.

 

[cook1082]

You have to enter the Bussiness name in the BCM but you also need MCDN keycode to get the name and for tat and tro also if centralized VM.

 

[ccarmock]

ah ok - so without the MCDN keycode names won't work anyway?

What about between just two BCMs?

 

[cook1082]

Same.You need them to see the names.

Check this out.

http://www.tek-tips.com/viewthread.cfm?qid=116673&page=909