Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Autoscript to a printer
- Thread starter jlg5454
- Start date
I'm not sure I understand your question. But if you want to be able to run commands like list stat schedule, you need to do the following.
Change node-names ip
Add your printer device name and ip address
change system-parameters features
On Page 5 (on my system), enter SYS_PRNT in the System Printer Endpoint field
SYSTEM PRINTER PARAMETERS
System Printer Endpoint: SYS_PRNT Lines Per Page: 60
Change ip-services
Add Service type SYS_PRNT, in local node, select a CLAN Board.
In remote node, enter the printer name you chose in node names
In Remote Port, enter the port your printer is listening on. HP Printers are typically 9100.
I hope this helps.
J
Change node-names ip
Add your printer device name and ip address
change system-parameters features
On Page 5 (on my system), enter SYS_PRNT in the System Printer Endpoint field
SYSTEM PRINTER PARAMETERS
System Printer Endpoint: SYS_PRNT Lines Per Page: 60
Change ip-services
Add Service type SYS_PRNT, in local node, select a CLAN Board.
In remote node, enter the printer name you chose in node names
In Remote Port, enter the port your printer is listening on. HP Printers are typically 9100.
I hope this helps.
J
- Status
Similar threads
- Question
- Locked
- Question