I had 3 2960's that were stacked. Now I need to repurpose those switches to operate stand alone.
I cleared the config but the switch that was switch 3 is still showing up as provisioned as switch 3.
When I look at the interfaces it shows g3/0/1...
I want it to be switch 1 not switch 3.
If I do a no switch 3 provision I get an error that the switch is attached.
Is there any way to get it back to switch 1?
I cleared the config but the switch that was switch 3 is still showing up as provisioned as switch 3.
When I look at the interfaces it shows g3/0/1...
I want it to be switch 1 not switch 3.
If I do a no switch 3 provision I get an error that the switch is attached.
Is there any way to get it back to switch 1?
