1140 Add on Module

[jacksonsmom]

Hi,

I am trying to program a 1140set with an add on module and am not having much success. I am programming through Ld 11 and I have KEM3 in the CLS, however, if I stat the phone it says KEM1 responding. When I try to add another DN to the add-on module it gives me a SCH code1366.

Can anyone tell me what I am missing in the programming end of things.

Thanks

Mary (non technical)

 

[bhassell2000]

try a different key, the sch code says that key ios reserved for SCU

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[jacksonsmom]

It then says SCH361.

 

[bhassell2000]

sch 1366 says dont use key 23 and sch 1361 says dont use key 18, try key 32 or something up in that area

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[jacksonsmom]

I tried to use key 12 and I got SCH361 also my add on module is not displaying anything, it is just flickering.

 

[bhassell2000]

KEM keys should go up yo 55 I believe, can you program a key up that far? Are yopu sure you have the correct KEM attached to the phone?

Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[nessman]

If you just have one add-on module on the 1140, then use KEM 1 in the programming, and program keys starting at key 32 and work your way up.

 

[jacksonsmom]

Hi again,

I tried changing the CLS to KEM1 and it gives me a sch0341 again.

 

[jacksonsmom]

Sorry I meant to say that I am only using one add-on module.

 

[bhassell2000]

its not in CLS, its a prompt like where Key or des is


Thanks,

Buddy

Linked in Profile

http://www.linkedin.com/in/buddyhassell

 

[yyrkroon]

Leave CLS alone, at the KEM prompt enter 1 then start programming your key on key 32 up to 53. Key 0-31 is the phone, key 31 to 53 is the first KEM (22 keys per KEM)

 

[jacksonsmom]

Thanks this worked - sorry this set is new to me.