Search results for query: *

Thank to everyone. That was it. Enabled the Transport tab to use the Network Topology and all is working great. Thanks again to all my tech hero's. Restored my faith in a Cisco RV320 Routers. It was my bad in programming the sip tabs in the ip office.

Ok thanks Pepp77. I will try that first thing this morning.

It is set to none. Do I need to to set it to LAN1 even tho I do not have a stun ip address?

Well, I and a local computer tech worked on this for a couple of hours of no avail. Tried several different settings in the Network Topology of no avail. Don't have a stun server to use and to run stun. The IT guy is going to bring over a different router than this cisco. Might have to use...

Thanks everyone for your replies. I will be back over on site tomorrow sometime and will change my topology settings. I will let you know if that was a fix. Thanks again

I have it filled out. http://files.engineering.com/getfile.aspx?folder=9e059d20-7c5a-4c48-a2f1-5f629efc544a&file=Doc1.docx

Hi everyone, I have an ip 500v2 ver. 9.1.5 with Sip trunks (with Nexvortex) for outgoing and incoming calls. No DID's just calls come in on sip trunk and are routed to a hunt group, rings a couple of phones then auto attendant picks up after 4 or 5 rings. Outgoing calls work great but no audio...

Cancel this Thread request. Found the info in SL1100 Features and Spec's Manual.

There is an annoying incoming call ringing in on our trunk lines. Is there a way to route that CID to a busy tone or to an announcement on an NEC SL1100 phone system? Thanks

Thanks very much for the info.

Can a IDS 84 station card work in an IDS 108 phone system?