Search results for query: *

Has anyone set up a D100 phone on 9.1 yet? I struggled for several hours trying to get the phone to connect. I did have it successfully connect twice only for the base to start rebooting after 10 or 15 minutes. The base was firmware 0.8.6 when on IPO 9.1. When I brought the unit back to my shop...

The user trying to log in probably needs to be set up as an SIP DECT user

Blast1234 what does 432000 equal in time? When I tried to set the dead pear detection to enable I lost my vpn. Right now my SA is 86400 and dead pear not enabled

I installed a Netgear 336 vpn router in December everything works fine with the two vpn phones that I have set up but it seems like I have to reset the vpn route every week because the IKE policies expire. What settings might I need to check in the vpn router to keep the tunnel active? do I...

I am an Avaya man by trade but have looked at and decided to sell the NECSL1100 as a secondary system. I am familiar with the old UX5000 (learned enough programming to be dangerous). Sold my first system today and will have product in my hands to play with awhile before taking out to site. It...

Has anybody had experience setting up a VPN connection with this router? I am upgrading from the 318 model and want to know if anyone would recommend or has used this for this type of application. Thanks

Thank you for all the comments. I advised the customer today that they need to upgrade their router and their data guy :)

Wspence, can you tell me what your 46xxx setting file is set to? Mine is "SET VPNPROC 2"

WSpence, that is exactly what I have on my phone. I can't for the life of me find the other settings that apply for Generic. I used that set u on a sonicwall it worked well. I am dealing with this netgear and a data guy that isn't a data guy. The first thread to my original question is what I am...

My profile is set to "OTHER" right arrow over then it shows PSK with AUX. When I changed my 46xx text file I removed # under the first box then put SET VPNPROC 2 in it's place. This is what I did on two other deployments of VPN 9600s phones that were using Cisco and Sonicwall routers and they...

I cannot see these settings in the 9620 - (Cert Expiry Check Disable Cert DN Check Disable) in the IKE parameters. I have the current firmware on the phone. I ran the 46xx settings from my 9.0 at my shop and can enable VPN mode and program everything else. The 46xx settings I am using is from...

Have any of you used the Netgear SRX5308? There is an configuration PDF from Avaya dated 2013 on the knowledge base. My biggest problem at this point is that I am limited on network knowledge and their data guy is not much better. The customer is also using AT&T UVERSE in bridge mode. I was also...

I do not see the some of the settings in my 9620l phone. Everything else looks the same. This is a 7.0 IPO with two IP Endpoint licenses. I established a IP local network connection with them and they are registered to the system. I ran the 46xxx setting file and can enable vpn mode. Am I...

I have a customer that has a Netgear FVS318n for their VPN/router. Has anyone ever successfully configured this type of router with a 9620L? I keep getting VPN tunnel failure/IKE no phase 1 response on the phone. Tried everything on the router in IKE policies, firewall, mode config, not sure why...