Search results for query: *

For the previous answer to work, go to the active physical lines, highlight the line and check out assigned DNs. Make sure they only appear on those two DNs, and make sure neither of those two DNs are Call forwarded on busy or ring no answer.

It is you rtransfer recall time under system programming. It defaults to 4. Set it higher than 4 to fix this.

If you two CCR trees available, set them up as "Home Mailbox Nodes" And assisgn the individual mailboxes to the diffrerent CCR trees. Have L73 set for AA after 6 rings Table W Then have Table W use CCR tree X(the new CCR tree you just created) Have L74 set for AA after 6 rings Table Y Then...

To reset the call pilot password: Feature 985 9 73738767793 This will default the password to 0000

If you are using target lines, the "received digits" cannot start with the same number as destination codes. You may have to call the lec and change the DNIS they are sending. Start your DNIS with a 1XXX. The park prefix is 1 by default and will not conflict with received numbers. For...

Hunt group members are ring only, broadcast ring using ring type 4. I did try making the members appr and ring, but that didn't help either. The problems happens if i use 24 ip phones, or 24 digital sets. I have also used analog trunks and pri trunks. It always happens, no matter what. If I...

CPU is not spiking, and I even doubled the ram and put in two more pec cards. Still no better.

I recently installed a BCM 400 4.0. I set up a hunt group with 24 phones, and 1 target line. When the number is dialed, first person to answer gets the call. It all works great until 4 or 5 incomming calls happen at the same time, then whenever someone goes offhook to answer, there is about a...