Search results for query: *

Thank you that solved my problem

Hi, I attached a CX300 to a host running RHEL4 U4 and presented 16 LUNs to the host. I can see all the LUNs in the /proc/scsi/scsi. I can also see all the devices in the /dev directory, from sda to sdo, but I cannot create the partitions for the devices /dev/sdi through /dev/sdo when I try...

Thanks for the information, I have the file .fdf but I could not get it to work. I thought I was only for upgrading firmware to drives that already have the EMC firmware in it.

Yes, the drive is in a working clariion, but the clariion does not see it. The drive is a Seagate ST3146807FCV and the current firmware on it is D010.

yes, I have a drive that is supported by the clariion, but it has the wrong firmware on it. It is also formated to 520 bytes/block.

I am trying to use this drive within a clariion

Hi, Can someone tell me how to flash firmware into a Seagate drive, and what tool can I use to do it? The frimware that Ineed to flash is not a seagate firmware therefore I could not use seatools to do it. Thanks, Luis

I formated the drive to 520/sector, and I checked on emc support matrix that the drive is supported by my cx300, but still does not work

I have an EMC CX300 and 2 Seagate Cheeta FC drives with firmware D010. THe drives were working within a JBOD box. I want to use them now within the CX300, but when i put the drives in the CX300, they go to a fault state, and navisphere shows that the capadity for these drives is 0. I think it...

Yes, The drive had the right bezel and target on it. It seems that there was some problem with the drive it self. I when to the process of installing the firmware on the drive for second time and now it works fine. Thanks anyway

I installed 1 LTO tape drive, then when I power on the library this message : targeting error problems comes on. The error appears only when this tape drive is in the library. The LTO is a seagate and it has the lates firmware, so does the library. Thanks

Thank you so much maultier, I finally got it to work. There was a problem with the null modem cable. Thanks, you were very helpful

Those are the only amber lights lit on the Clariion. Thanks

I noticed something on the DPE, The lights on the top wright corner there are both on all the time, the amber and a green lights. Thanks

I powered cycle the Clariion but I still did not see anything, I am going to make sure the setup is correct. Thanks

The lights on the storage processors are green. When I power up the FC4500, and tried to connect through the hyperterminal, using the null modem cable the hyperterminal just hangs there and I can't get to the fcli> prompt. I also tried changing the settings to 19200 and 9600 both with 8 1 and...

I don't see any green ligths. only the amber lights with an X on top of a battery are on. What do they mean. Thanks

Hello I inherit a EMC FC4500, and I can't get acces to fcli. I tried {}{},and also @$@$ but still does not work. I don't see the unit from navisphere either. Can someone please help. Thanks