Search results for query: *

I have failed CCNA three times now and im about to jump out a window. I can subnet, configure ext/std/named ACL, and i understand all the basic topics, but i have failed it everytime by a few points. My last score was 809 and before that i got 842. I've been having problems with this lab...

Guess what, I just took the CCNA test again. 809 out of 1000 this time. This is the 3 time i have failed this test. AGGGHHHH!!!! Now that ive got that off my chest... One of the questions in my lab that i failed is related to the above question, but i tell you the question again in...

I'm having a problem with one of my questions for my CCNA lab. The question is "How do you determine where a VTP update originate from? What command do you use on your client switch?" The situation is that your switch is the client and there are 3 other switches, so how can you find out where...

You have been really helpful. thank you. I bought the Cisco Network Acadamy program from ebay and i noticed that the copyright is dated 2000. Therefore, that would explain the BRI interface. I believe i still might pass the CCNA because the general concept still remains the same. What do you...

1. I'm studying for the CCNA and im stuck. How do you connect the cisco router to the internet? the router has a BRI port. I did some research and that port is supposed to connect to a ISDN modem. Can i plug the BRI port into my home internet modem? I have bright house cable. 2. Also...

I'm studying for my CCNA and i have gotten stuck at a certain point. I just figured out how to load the default configurations that you save into your NVRAM. While figuring this out, I added too many incorrect boot system load entries using this command: boot system flash <filename>. What...

FINALLY, I was able to access the router by using the 1200 Baud rate. It still stated "HD(1): Reset from 0x107E808 ", but I just waited for a couple of minutes and it gave me a prompt to configure the device. I wonder why I was able to access the router at a faster speed but now i can only...

I tried all the baud rates, but that didnt work. Are there any commands that i can type in the AUX port to fix the problem with the router?

Helpdeskdan, I know the cable is working because the cord works in another cisco router's console port. I followed the instructions in the article that i stated and I didnt have any problems until I typed "reload" The baud rate that I used before this problem is 9600, but now when i use that...

Im studying for my CCNA and I bought a cisco 2500 router. When i received the router it had a secret password when you type "enable". I followed the instructions to reset the password and rebooted the router using the instructions in this article...