Search results for query: *

Hi, I have a Cisco router that freezes after the Ios is loaded. Right after this output from the device; "This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products...

you would also need an ip route 0.0.0.0 0.0.0.0 dialer 1 and a specific NAT statement if you are natting.

The ATM is indeed the actual card. The Dialer interface is as such virtual. The Dial pool member is just using what is stated in the dialer as Dialer pool,

An example You will need to do this in sys mode. interface Ethernet1/0/1 poe enable stp edged-port enable (Otherwise your port will take a while to come up) port link-type hybrid port hybrid vlan X tagged (Your Voice VLAN) port hybrid vlan 1 untagged (Your Native VLAN)

Is this in an outbound or inbound direction?

If you are using the same port for Phones and data you need to configure switchport mode hybrid on the 4500, it is the equivalent to the cisco voice vlan

I am uk based and we set our DSL's like this. interface ATM0 (SLOT NUMBER) no ip address no atm ilmi-keepalive pvc 0/38 encapsulation aal5mux ppp dialer dialer pool-member 1 interface Dialer1 description *** ADSL ON BT NUMBER XXXX XXXX *** ip address negotiated (May be different for...

Hello, I need to find the OID so I can query one of our core Routers so I can check the state of some Xconnects we have. I would also like to check the traffic in/out bits on the subinterfaces we have active for the Xconnects. I have been reading up on SNMP however do not seem able to find the...

We deal with alot of Cisco kit. So much so we stopped using smartnet a year or so ago, we have a model of each current device in stock so we can deal with a device failure. This has however bit us on the backside where software updates are concerned however. In my opionion I would deffo go for a...

amriddle01 have BT got their own SIP platform or are they just using a whitelabelled product? I have a feeling its the latter but I may be wrong.

If your PRI NTE is miles from the NTE, alway try to get it within 5 metres of the terminating equpment. Get the line provider to move it (Official statement) Slips are not good and 100ft your lucky to be working at all, I am suprised you are not getting poor quality calls and cut offs/

I would say an IP500 too. Its going to keep you in date for a lot longer.

Im not banned yet.

I am hoping some one can help with a little Advance setup please. We have added another 15 25 channels of SIP into our company and have another PRI E1 card uplinked into our PaBX. I need to ensure that my plans are right to ensure when 30 channels on card one are used it over flows into card 2...

granted. I'll go back under that rock

Indeedy, Works a treat.

Have you a shortcode matching just "1" in the user? Ie 1 Feature dial 1 Line group X

Call cuts off are probably going to be related to connectivity qos issues. Or a common one we have is NAT refresh on the firewalls. Where by the firewall only holds the connection open for a particular amount of time before shutting down. As above though what is being sent or recieved from the...

As said above that is only showing as dialling "1" When the fax is dialling how quickly does it dial the digits, it isnt by chance going over the digit to line timer is it?

are packets flowing both way rx and tx in the tunnel?