Search results for query: *

Guys finally found the solution it's was so simple but hard to find : ------------------------------------------------------------------------------------------------------------------- Fake Answer Supervision after Outpulsing : Yes ignore Answer Supervision : Yes Release Supervision Expected ...

Hi This thread will help you to deal with echo problems encountered when programming Analog trunks. For those who are experiencing echo when making external calls ( echo for about 5 sec / echo all the time / silence for about 5 sec / one way audio ), Here the solution : In the CO Trunk...

Hi Again So after 1 week of playing with the 3300 CX II, i found the best setting for my country, here bellow my results : --------------------------------------------------------------------------------------------------- * changing the country does not any effect on the echo, but will...

humm the think is when i remove an analog line from the mitel and use it with an simple analog phone, the trunk work perfectly. damn this is frustrating.

I'm located in Tunisia and my CO provider does not use ATA, the trunks are pure analog. i tried every possible combination for the balance Network settings for both CO and analog trunk form. since there no recommended setting for my location i used France instead. ( HTRM Page 49 ).

hi you need to configure a port on the switch with an access to both ( Vlan voice + Vlan data ). put the gateway ip adress in the mitel LAN form. and plug the LAN Mitel port in the new port on the switch. note that when you do the last step all phones will be off for about 1 to 2 min.

Hi I got the exactly the same problem, i did run the LMT in loop back mode and result says [ YELLOW - ERL -17.945 ]. I tryed evey tip in the book and no result, i think that changing the country may help to fing the right impedande. Playing with audio inhibit and fake answer does not help...

Hi sarond Can you please describe how did you program the class of service and the class of restriction ? I tried to change the ARS digit lead from 0 to 9 but i still have the same problem. Also I checked that all routes are not programmed as emergency routes but its seams that I miss...

0 is configured as ARS access code. No Internal number is configured as local operator. Routes for external calls are not emergency routes.

When the IP phone is locked, internal call are forbidden but users still can dial 0 and make an external call. Can you please Help ?

Yes it's grounded

I got an issue with a Mitel 3300 : The ICP have 6 LS Trunk connected to him and sometimes 2 users get crosstalk when they making an outgoing call via Analog Trunk. Can you please help.