Search results for query: *

I keep mine on the bulletin board

you might also have to change the ds1 board to speech & not 3.1khz

jusu disconnect & go back in, but use the right term type

press enter

reorder can come from vendors, your trace looks ok, do you get the same result each time? can you route it over a different pri?

1 - in rare cases, you can lock up the modem line by disconnecting incorrectly 2 - you can look at page 2 only if something is programmed there. 3 - there are no dumb questions, only stupid answers

do you have access to the PBX, the port of the station is reflected on the 110. is the 110 labeled with anything like 01a or numbers similar?

do you have a point to point tying the 2 sites together?

That needs to be done via an order to your circuit vendor. also, you may have to add a directory listing.

the programming should be the same

i use them & they have worked fine.

viking box

can't you use the private numbering to ensure the correct digits are being sent over the q-sig tie

for an analog card you just have to physically remove it from the pbx

you can load the lic file thru the web interface, just scroll down to the lic file section & from there you can download it.

do you have the old lic file?

well, then you will have to seperate them by COR & use partiton routing for thier outgoing calls.

is tenant partitioning turned on?

list con carrier XX - XX being whatever the board is 1a02, 1a03 etc...., then display the port being used.

your trunk groups should be wats type, second page make it automatic.