Search results for query: *

i added one magzine to LIM 9, and detected by the system. i initiated the TMU and ELU33 and configured the digital extension. when i dialed from that new extension which i configured in new magzine other party cannot hear me but i they can hear me. version BC13 sp5 please suggest some solution

how to upgrade iplu firmware in tsw sp03

how upgrade the firmware for iplu card in tsw sp4

WHEN IAM LOADING THE SYTEM WITH TSW SP04, LIM 1 IS LOADING WITHOUT ANY PROBLEM. LIM2 IS NOT LOADING IT IS COMING UPTO 2700 ON LPU DISPLAY AND AGAIN IS IT GOING BACK TO 9064. I CHANGED LPU,LSU AND DSU BUT STILL THE SAME PROBLEM. PLEASE ASSIST ME.

how to calculate the correct bandwidth for each voice call through e1 link using ip telephone. please help

Please check this <OPCGP:DIR=ALL; OPERATOR CALL ORIGIN GROUP DATA DIR 4 9 9 9 CORG - 1 1 END <OPCAP:DIR=ALL; OPERATOR CATEGORY DATA DIR OPC PRG TRAF TRM 4999...

just help clearly i have operator number 4999 if i want to call the DID as incoming call i have to dial 8494999 if iam local. Please give the example programing for this

how to configure the operator to accept the DID calls directly

how to configure DID on operator

Thanks Dave ! I did the same as u suggested it work, now the system is working stable. Thankyou very much

I HAVE ONLY ONE GSM 0, I HAVE TWO LINKS FOR LIM 4 I TRIED TO BLOCK ONE LINK AND TRY THE DUMP SAME PROBLEM I FACED I CAN'T MAKE DUMP. WHAT IAM PLANNING TO DO IS CHANGING THE GCU2, BY SWITCH OFF THE GROUP SWITCH. OR IF U HAVE ANY SOLUTION PLEASE ADVICE

VERY VERY THANKS TO ANSWER MY QUESTION I RESTARTED THE LIM 4 AND PROGRAM UNIT, I HAVE TWO LINK IN LIM 4 I BLOCK THE ONE LINK AND TRY TO DUMP SAME PROBLEM. I WANT TO TRY TO SWITCH OFF THE GROUP SWITCH AND RESTART AGAIN. GIVE ME YOUR SUGGESTION.

UNABLE TO MAKE DUMP TO THE SYSTEM GETTING STUCK AT PROGRAM UNIT DDGM IN LIM 4. ALARMS IN MD110 IS THE FOLLOWING 1) CODE 88 Group switch module clock alarm. 2) code 65 Synchronization fault in LIM. in group switch getting the E5 error.

Need help! Here i configured and E1 voice card for cisco with ericsson MD110 PABX it was working o.k just now iam getting problem i can use only one channel at a time. I enabled the thirty channels in cisco and ericsson.

i didn't find any blocking on the trunks, if i refresh the call logging program unit it will be o.k for 15 days and again it will generate the same problem. The 9hrs calls in not one site problem we have lot of site installed with bc9 and bc12 but still the problem is the same in the ring master

In bill system ringmaster i find lot of calls for 9 hrs or above. The trunks are analog please give your suggestion on this The following are the route parameters TL11 H'00000022 H'00000708 H'00008815 NO