Search results for query: *

change abbreviated-dialing system Page 6 of 7 ABBREVIATED DIALING LIST SYSTEM LIST Label Language:english DIAL CODE LABELS (FOR...

For the single line phones (2500) go to page 2, add system to Abbreviated dialing list1. Change abbreviated system pick an available system list and enter a 9 back to the station form, page 2, for the Hot line destination add a 1 and the dial code is the system abbrivated dial code you just...

What type of phones are you using?

Just what I was looking for, thank you.

Does anyone know if I can replace a 397B Power Unit with a 397C Power Unit?

Anyone have any idea if this is possible? The closest I've come to it is the "man date" command.

A reset system 1 will send a warning out through INADS

list measurements ds1 log 01A01(your ds1 here)

I finally gave up after changing all of the codec settings and called Avaya. The solution they gave me was to update the firmware on the medpro card, so we'll give that a shot and take it from there.

I am unable to send a FAX from a remote site (G700) to the main site (S8500) over a WAN. The FAXes don't come out right or not at all. I understand this has to do with the conversion from TDM - IP and changed the IP-Codec fax field to pass-through, but faxes still won't go through, and ideas?

Your FRL is 0, can you make outside calls with an FRL of 0?

change system-parameters maintenance

The probblem with Reset 1 is that they won't be able to make any new calls durring that 15-30 sec period. For a hospital that a probblem.

I did speak to avaya, they said we need to apply patch 42.97, this fixes a probblem with a counter of some sort being stuck. The patch removes the counter. I'm not abbly to use this fix because it requires a Restart System 1, and this is a hospital.

it's the 866 # for AlarmTraq. It's sounds like the switch isn't even trying to dial out. I'm not sure if there is a way to force it or not.

Alright, I'll give Avaya a call Thank you.

This is a new probblem, testing the INADS link has worked up untill this month, nothing has changed as far as i can tell. here is what error type ll says. The switch is trying to report alarms to INADS. The test cannot be run at this time. 1. Wait 10 minutes and retry the command.

Sorry, this is a Difinity G3rV9.

Test INADS-LINK, command fails when I look at the Hardware Error Report for INADS, I get error type 11, the only fix listed is to wait 10 min and try again. I've tried it in 10, 20, and 30 mins. I waited till the next morning after the nightly maintenance, still the command fails. Any ideas?