Search results for query: *

Hi, is there any feedback on whether it finally worked or not?

Do DUSYI; twice. This will cause both REL1 and REL2 to be overwritten with current programming, but have synchronised time.

Hi, Thanks for the reply. With this fault I have tried both with it enabled and disabled but the fault remains the same. However, I have permanently adjusted my ooh323.conf below: general] port=1720 bindaddr=192.168.100.95 h323id=asterisk e164=100 callerid=asterisk gateway=no...

OK, let's go to the basics: 1. You have a licensed IPU 2. You have created a Trunk route containing only the IP trunks of THAT IPU (if you have more than one IPU) 3. You have set the address on the IPU 4. You have added your own IPU and the cisco IP to the 1000 node table 5. You created a PNR =...

Then under your private network router, have you set "Predigit removal" = 3? Also, number length (complete and subscriber) = 3 (to allow it to wait for the extension number 200) Test that first. If it fails I can provide another method to test.

Hi, Unfortunately I have no setup between a Cisco and BP. You mention that you dial 057XXX to call the cisco. Can you provide a some sample extensions as they reside on the cisco pbx? (e.g. 57000, or 7000 or 200)

Hi, I am using OOH323 (Asterisk 1.8.21) to link to an Aastra BP250. Calling from the Asterisk to the Aastra works fine. When I call from the Aastra to the Asterisk, there is no speech. Once I press a DTMF button on the Aastra PBx, then a long tone is heard on the Asterisk phone (SIP) and the...

HI, Does anyone have a working config for h323 between Asterisk and an Aastra BP250? The internet posts are a bit outdated and no longer compatible with newer versions of Asterisk, e.g. recommending OH323 but only OOH323 is available. Any successful implementations will be welcome.

Under you PNR, you can set the complete call number. Then the BP250 will send it as enbloc. It will wait for all digits before transmitting them.

Since you have only mentioned the 088 role, at which point do you dial 057? Are you using PNRs?

Appreciate the feedback. Thanks.

My first post. I am trying to connect a Siemens HiPath 3000 to an Aastra BP250 with H.323 trunks. Signalling works fine, with CLIP, but no speech. Using standard PRI and ECMA1 then everything works. But the Siemens can not do ECMA1 with H.323. Any suggestions besides getting a IP gateway?