Search results for query: *

Check to see what DRT to prime is set at, if it's the same number of rings as CFW then it will ring the prime set for that line. If this is what is causing the problem change DRT to prime to 8 or turn it off

You have to check to see which relay you are using on the DOC. If you are using the NC relay and the key pad is NO then the DOC will never open the door because the circut is never completed. The best thing to do is get a relay that can be triggered by an NC and a NO contact to open the door.

Make sure supervision is turned on on the lines for this to work.

If it's a Nortel/Polycom conference set you can have to intercoms programmed and it will work for 2 external callers and 1 internal or 2 internal and 1 external. If you have centrex lines you can use the conference feature on the line this works well.

Why don't you use a cta 100 hooked up in line with your set and a null modem cable connected to computer. This will allow you to use your address book on the computer to dial phone numbers via your set.

flip the set over and read the tag on the back it will say ether t7316 ort7316e

It Started at 4.0 software

Dumb question did you enter an ext. number in when the mailbox was built to associate the ext. to the mailbox?

Unplug the call pilot run the xf test and remove all the voice mail feature codes then uplug the call pilot back in and it will reload the feature codes back onto the ksu.

I agree with jerryreeves Ive been using the MCK product to tie to greenhouse operations together on a wireless bridge between the two locations.It works great just have to adjust the latencies every once in awhile to reduce echo.

You can pass digits thru the page port from any set except a digital mobility set.Also are you sure it says line not in use or is it displaying not in service.If it's displays not in service you've got the wrong line programmed on the set.You don't need voltage on a line for you to be able to...

If you are not using mailbox 100 you can turn it off so there is no general delivery mailbox.This is done under f983 Log in press 6 then change y to n

The reason the serial cable from the rad won't work is because the digial mobility needs a null modem cable for it's serial connection.

Everyone is going in the right direction,check the time of day the problem happens. Ive found in the past problems with not enough channels to access voicemail show up first thimg in the morning and just after lunch. These are high voicemail user times as everyone gets back to the office and...

Curlycord is right check it with a laptop early software versions had a boot loader failure. This would cause the cp150 to start to load ie: lights flashing then lockup half way thru the load and stop working.

You may have to change the supervision timer up or down to correct this problem. I have had this problem on long co loops where the telco says the supervision is there it just slow because it's at the end of the line. This is usually in the rual areas it happens.

All you need is any self-amplfied horn hooked up to the headset port of the phone.

When you close the business 'F982' the only greeting that plays is the non-business until you open the business.Your CCR trees still play at the times you have set up.

You get that message if the supervision is turned off.

White noise can only be heard when music volume on set is turned up full which would make the ring very loud in an office area.